• - Cold Forming Elbow Machine
• - Hot Forming Elbow Machine

• - Pipe End Expanding Machine
• - Full Length Pipe Expander

• - Single-Head Pipe Fittings Beveling Machine
• - Automatic Double-Head Elbow Beveling Machine
• - Automatic Triple-Head Tee Beveling Machine
• - Large Steel Pipes Beveling Machine

(1) The optimization design of the whole frame fuselage of the three-way machine ensures the strength. The welding parts are inspected for non-destructive flaw detection. After welding, the aging treatment is carried out to ensure the complete elimination of stress and no deformation occurs in the use of the equipment.

(2) T-shaped grooves are arranged below the slider and above the worktable for mounting the mould.

(3) It is provided with a locking device for the dead point of the slide block to prevent the slide block from sliding.

(4) the power mechanism is arranged on the top of the machine, and the top of the fuselage is provided with a safety platform and a fence.

(5) The slider guide rail is lubricated by non-recovery type automatic circulating thin oil, and equipped with oil receiving box and fault display device.

If you need more introduction and parameters of the three-way machine, welcome your consultation.

The main part and composition of the three-way machine

The three-way machine is mainly composed of oil pump, motor, PLC control box, water tank and corresponding model molds.

The body of the three-way machine is a non-standard product, so there is no detailed specification and model. We can customize the three-way machine according to the customer's request.

The diameter of the tee is 21mm-630mm and the wall thickness is 3mm-20mm.

The function of mechanical tee and ordinary tee is different.Mechanical tee is divided into groove mechanical tee and screw mechanical tee.It can be used to connect branch pipe directly on the steel pipe, and has more applications in the device of fire fighting pipe and spray pipe.The mechanical tee can be used when diverting or confluence is required.

The device method first uses a hole opener on the steel pipe, and then the mechanical tee is stuck into the hole, and the hole is sealed by a sealing ring along the pipe wall.Mechanical three - wire connection and groove type two.When the mechanical tee is connected, the clearance between the mechanical tee and the hole should be checked, and all parts should be average, and then fastened in place;Mechanical tee hole spacing should not be less than 1m.

2203-2202.