| Analysis of elbow machine in pipe fitting equipment
Aogang machinery equipment Co., Ltd. mainly produces all kinds of pipe fitting equipment, pipe fitting equipment is divided into: elbow machine, pipe bending machine, pipe expanding machine, press machine, groove machine, tee machine and so on. The above pipe fittings equipment and manufacturing has many years of manufacturing experience, all in our company to order the above pipe fittings equipment customers our company will provide customers with excellent pipe fittings equipment at low prices.
Bend machine mainly include alloy core head, intermediate frequency coil bracket, intermediate frequency coil, export support, pushed the door open, hydraulic cylinder, after pushing plate, gate, hydraulic lift cylinder, the main oil cylinder, cylinder bracket, after feeding the core rod, the big chassis, oil cylinder, motor, axial plunger pump, integrated block (which installation of the hydraulic control valve), etc.
Elbow machine main engine, hydraulic pump station, control console, motor control cabinet, if power supply, compensation capacitor, water cable, if coil adjustment frame, reactor. The cut raw material is covered on the core rod of the elbow mold, the intermediate frequency induction wire is set in the end of the elbow mold core, the cooling water pump and the intermediate frequency power supply are started, the raw material is heated to about 800 C, and then the pushing machine is started to push the elbow.
According to the push elbow to choose the main push pump, select the rate of feeding, gate gate, manrod heating to the temperature of things to start to push, push the speed is adjustable, push to the middle point of the push machine to actively stop, hydraulic gate gate, core rod feeding, release the gate retreat to the end, gate gate to the rod diameter began to push. Note: the main pump can be used at the same time, as the usual environment can only use one. It can also be used as an undeterred retreat. The retreat pump can not be used at the same time, only one can be started, the other one standby. Feeding pump can only be used when feeding. The stable pressure of the main oil pump hydraulic system is set, and the stable pressure of the cylinder hydraulic system is set. Push machine travel is equipped with travel switch at both ends, the real travel should be less than the big travel, that is, the movement of the push plate before and after both ends from the real end of the remaining amount, so as not to run the cylinder piston to the end.
|
