• - Cold Forming Elbow Machine
• - Hot Forming Elbow Machine

• - Pipe End Expanding Machine
• - Full Length Pipe Expander

• - Single-Head Pipe Fittings Beveling Machine
• - Automatic Double-Head Elbow Beveling Machine
• - Automatic Triple-Head Tee Beveling Machine
• - Large Steel Pipes Beveling Machine

The components of push machine: elbow push machine host, hydraulic pump station, operating table, motor control cabinet, intermediate frequency power supply, compensation capacitor, water cable, intermediate frequency coil adjustment frame, reactor.  

Introduce the working principle of the push machine, or when there is any fault of the push machine, we will also solve the problem, but what is the purpose of the real push machine? We may not know, our company will simply introduce it to you:  

Set the cut raw material on the elbow mold core rod, trap the intermediate frequency induction line at the end of the elbow mold core, start the cooling water pump and the intermediate frequency power supply, heat the raw material to about 800°C, and then start the push machine to push the elbow.  

Select the main push pump according to the push elbow, select the speed of feeding, gate gate, mandrel heating to the working temperature began to push, push speed adjustable, push to the midpoint push machine automatically stop, hydraulic gate brake dead, core rod feeding, release the gate back to the end, the gate gate to the rod diameter began to push.  Note: main push pump can be used at the same time, generally only one can be used.  Can also be used to retreat without stopping.  Backward pump can not be used at the same time, only one can be started, the other standby.  Feeding pump can only be used for feeding.  The steady pressure of the hydraulic system of the main oil pump and the hydraulic system of the auxiliary cylinder shall be adjusted as follows.  Both ends of the stroke of the push machine are equipped with a stroke switch, and the actual stroke should be smaller than the larger stroke, that is, both ends of the active push plate are left from the actual end point of the margin, so as not to run the cylinder piston.  

The company mainly produces customers need to push machine, bending machine, tee machine, expanding machine, press, beveling machine, straight pipe production line, mold and so on.  Welcome users who need the above pipe fittings and equipment to our company to visit and order!