• - Cold Forming Elbow Machine
• - Hot Forming Elbow Machine

• - Pipe End Expanding Machine
• - Full Length Pipe Expander

• - Single-Head Pipe Fittings Beveling Machine
• - Automatic Double-Head Elbow Beveling Machine
• - Automatic Triple-Head Tee Beveling Machine
• - Large Steel Pipes Beveling Machine

Aiguang co., Ltd. mainly produces medium frequency elbow machine, medium frequency pipe bending machine, medium frequency pipe expanding machine, elbow pushing machine, beveling machine, straight seam welding pipe production line, aligning machine, medium frequency power supply, and all kinds of different types of moulds for the above pipe fitting equipment.  The company in the manufacturing of advanced technology and manufacturing business philosophy, for each customer to provide satisfactory service and equipment, welcome the need of the above pipe equipment customers to visit the company consulting!  

Intermediate frequency bend machine manufacturer introduces the composition of elbow machine: attention, hydraulic pump station, operating table, motor control cabinet, intermediate frequency power supply, compensation capacitor, water cable, intermediate frequency coil adjustment frame, reactor, etc.  

Working principle of intermediate frequency elbow machine: the cut raw material is set on the elbow mold core rod, the intermediate frequency induction line is trapped in the end of the elbow mold core, start the cooling water pump and intermediate frequency power supply, heat the raw material to about 800°C, and then start the push machine to push the elbow.  

Select the main push pump according to the push elbow, select the speed of feeding, gate gate, mandrel heating to the working temperature began to push, push speed adjustable, push to the midpoint push machine automatically stop, hydraulic gate brake dead, core rod feeding, release the gate back to the end, the gate gate to the rod diameter began to push.  Note: main push pump can be used at the same time, generally only one can be used.  Can also be used to retreat without stopping.  Backward pump can not be used at the same time, only one can be started, the other standby.  Feeding pump can only be used for feeding.  The automatic pressure of the main oil pump hydraulic system is set as, and the steady pressure of the auxiliary cylinder hydraulic system is set as.  Both ends of the stroke of the push machine are equipped with a stroke switch, and the actual stroke should be less than the large stroke, that is, the two ends of the active push plate are left from the actual endpoint of the margin, so as not to run the cylinder piston.  

Medium frequency bending machine manufacturers for each user to order satisfactory approved pipe equipment.  Our company 24 hours welcome your consultation!