| Power analysis of elbow machine
Power analysis of elbow machine. The efficiency of the elbow machine under the use of high power will slowly decline with the use of time, the decline of the lamp power will also affect the laser power. In addition, because ordinary purified water contains a large number of microorganisms and various ions, these impurities can easily adhere to the high temperature lamp wall, which also reduces the efficiency of the lamp.
Heating deformation of elbow machine. The symmetric parallel planar cavity has a large modulus in the crystal. With the increase of the power, the heating deformation of the lens leads to the change of the cavity shape, which never converts the chaotic cavity into an unstable cavity, thus affecting the laser power output.
Mold thermometer as an indispensable temperature control equipment in industry, has been in 24 hours of work, so it is very important to choose a good performance of the mold thermometer. Due to the thermal expansion and contraction in the process of mechanical transportation and operation, the terminal nut is loose, the current is too large, the terminal copper foil can be oxidized, and the heating tube and contactors can be burned out by short circuit. The maintenance method is as follows.
Remove the rear seal of the device, open the wiring cover of the heating pipe, and tighten the nuts of each wiring and the nuts of the copper connecting part (including the nuts under the copper) with corresponding sleeves.
When the water/oil pollution of the machine is serious, remove the entire heating pipe, clean and maintain the surface of the heating pipe and the inside of the heating pipe to prevent the drying and combustion of the heating pipe caused by the bad back and forth of the system.
When mold temperature is not used, cut off the cooling water connection pipe, clean the residual cooling water/heat conduction oil in the pipe, and pack it in a dry place for storage.
The machine needs to stop production for a period of time: when the power supply is connected again, clean the Y-shaped filter and heating pipe at the hot oil inlet. Because the machine does not work for a long time, oil and foreign matter accumulation will lead to bad movement of the machine and do not shorten its service life.
Maybe we all know how elbow machines work, or fix them when they fail, but we may not know what real propulsion is for. The following is an analysis of the use of elbow machine:
Elbow unit parts: elbow machine host, hydraulic pump station, console, motor control cabinet, IF power supply, compensation capacitor, water cable, IF coil adjusting frame, reactor. Power of elbow machine.
| 