| How to deal with the failure of pipe bender
When the oil pump of the pipe bender fails, we should put a sheet of the same thickness on each side, remove it and work more than 90 degrees, and measure the Angle with an Angle ruler. The connecting rod connecting the two worm gear holders on the hydraulic pipe bender is detached. Just pull to one side. There's a spring in there to stop it from falling out. Compare the two plate angles. If the right Angle is large, rotate the right link clockwise. Slightly turn a certain position, fold plate measurement. We won't be able to troubleshoot everything until we have all the angles modulated.
Through the above introduction to the treatment method of pipe bender failure, our company briefly introduces the need for regular maintenance and detection of pipe bender, so as to reduce the failure of pipe bender in the operation process.
The following is a brief introduction to the detection and maintenance of the pipe bender; First check the fasteners in each part of the pipe bender to make them in a tight state. Oil resistant rubber rings are installed in the joints of the hydraulic pump tension part of the pipe fitting equipment. If the seal is damaged or oil leaks, it should be replaced in time. If the forward and backward failure is found, first check whether the solenoid valve works. If the solenoid valve works normally, then check whether the sequence valve, relief valve, or one-way unloading valve is stuck by debris. This phenomenon is generally easy to occur when the pipe fitting equipment begins to be used. If there is a stuck phenomenon, open with diesel cleaning, reinstall it. Clean the tank and filter the hydraulic oil once within 1-2 months after the pipe fitting equipment starts to be used. When cleaning the tank, the inlet filter of each pump should be cleaned. The above is a brief introduction to the maintenance and protection of pipe fitting equipment, hoping to help you.
|
