Pipe bending machine is a kind of machine specially used for bending pipes, which is widely used in machinery manufacturing, aerospace, automobile manufacturing, petrochemical, construction and other fields. Now let's briefly introduce the use of the pipe bending machine.
1. Preparation: Before using the pipe bending machine, it is necessary to carry out some preparation work. First of all, check whether the various parts of the bending machine are normal, whether there is fault or damage, and if necessary, it needs to be repaired or replaced. Secondly, it is necessary to choose the appropriate bending mold, and select the corresponding mold according to the outer diameter of the pipe to ensure the accuracy and quality in the bending process. Finally, screw the working cylinder into the inner thread of the square stop block and mount the rear end of the cylinder on the wheel down on the bracket.
2. Install the mold: set the selected bending mold on the plunger, put the corresponding groove of the two rollers towards the die head, and then put the corresponding size of the flower plate hole, and then cover the upper flower plate. When installing the mold, be sure to pay attention to the position and direction of the mold must be correct, otherwise it will lead to incorrect bending or damage.
3. Insert the pipe: Insert the pipe that needs to be bent into the groove, adjust the position of the pipe, align it with the mold, and ensure that the two ends of the pipe are firmly fixed together with the clamping device of the bending machine.
4. The pipe bender is connecting the high-pressure oil pipe; Pull the quick fitting moving part of the high pressure tubing end back and put it over the fitting of the working cylinder, then tighten the oil drain screw on the electric oil pump to ensure that the oil will not leak during operation.
5. Start pipe bending: Start the electric oil pump, put the oil hydraulic pressure into the working cylinder, and push the bending mold through the movement of the cylinder to bend the pipe along the predetermined bending radius. During the bending process, attention should be paid to controlling the oil pressure and speed to ensure the accuracy and quality of the bending.
6. End pipe bending: After the bending is completed, stop the oil pump, loosen the quick connector on the high pressure oil pipe, and take out the bent pipe. At the same time, all parts of the bending machine should be cleaned in time to keep the machine clean and normal operation.
The above is the introduction of the use of the pipe bending machine, I hope to help you. When using the pipe bender, we must pay attention to safety and operate in accordance with the operating procedures to avoid accidents. Refer to the operation manual of the electric oil pump.
Never remove the quick coupling under load. This machine is oil as the medium, we must do a good job of cleaning and maintenance of the oil and the machine, so as to avoid blockage or oil leakage, affecting the use effect.
Aoguang pipe fittings equipment manufacturers mainly produce all kinds of pipe fittings equipment, welcome the need to produce and process pipe fittings equipment users to consult and order!
For more knowledge about pipe bending machine manufacturers, please pay attention to our website: http://www.fitting-equipment.com
| 